thanks for reading this message
I'm trying to configure virtual serial port by Eltima with the following features:
- A transceiver with a serial port on COM 1 (Port real)
- A microprocessor with PIC16F877A serial port on COM 4 (port real)
- A virtual COM5 which connect the transceiver control software.
I tried to redirect between COM1 and COM4 everything runs smoothly. The the radio
connects with the PIC16F877A properly.
Now I have to install a virtual port COM5 but I can not find the right configuration (join, spitter or other).
PIC16F877 on COM4 has only three wires (RX, TX, GND).
I hope I explained myself well.
Please if anyone can help me in the right configuration.